全文获取类型
收费全文 | 611篇 |
免费 | 95篇 |
国内免费 | 507篇 |
专业分类
安全科学 | 41篇 |
废物处理 | 116篇 |
环保管理 | 42篇 |
综合类 | 680篇 |
基础理论 | 138篇 |
污染及防治 | 174篇 |
评价与监测 | 16篇 |
社会与环境 | 5篇 |
灾害及防治 | 1篇 |
出版年
2024年 | 3篇 |
2023年 | 19篇 |
2022年 | 39篇 |
2021年 | 44篇 |
2020年 | 41篇 |
2019年 | 64篇 |
2018年 | 59篇 |
2017年 | 47篇 |
2016年 | 50篇 |
2015年 | 65篇 |
2014年 | 75篇 |
2013年 | 73篇 |
2012年 | 76篇 |
2011年 | 78篇 |
2010年 | 39篇 |
2009年 | 69篇 |
2008年 | 30篇 |
2007年 | 62篇 |
2006年 | 33篇 |
2005年 | 40篇 |
2004年 | 23篇 |
2003年 | 21篇 |
2002年 | 27篇 |
2001年 | 28篇 |
2000年 | 19篇 |
1999年 | 26篇 |
1998年 | 10篇 |
1997年 | 10篇 |
1996年 | 8篇 |
1995年 | 7篇 |
1994年 | 7篇 |
1993年 | 4篇 |
1992年 | 6篇 |
1991年 | 2篇 |
1990年 | 4篇 |
1988年 | 2篇 |
1986年 | 2篇 |
1984年 | 1篇 |
排序方式: 共有1213条查询结果,搜索用时 17 毫秒
1.
采用溶胶-凝胶法制备了Mn掺杂钙钛矿型催化剂LaFexMn1-xO3,并以其为催化剂催化湿式双氧水氧化处理煤气化废水纳滤浓缩液。采用XRD,SEM,FTIR技术对催化剂进行了表征。表征结果显示:制备的催化剂均具有标准的钙钛矿型结构,其中,LaFe0.9Mn0.1O3的结构稳定,比表面积大。实验结果表明:制备的催化剂中LaFe0.9Mn0.1O3的催化活性最高,且稳定性好,连续使用5次后催化活性未见明显减弱;在H2O2投加量3.0 g/L、n(H2O2)∶n(LaFe0.9Mn0.1O3)=12∶1、反应温度160 ℃、反应压力1 MPa、浓缩液pH 3、反应时间60 min的最优条件下,COD、UV254和TOC的去除率分别达到80.9%、95.2%和68.0%,BOD5/COD由0.02提升至0.40,可生化性大幅提高。 相似文献
2.
Ana L. De Toffoli Bruno H. Fumes 《Journal of environmental science and health. Part. B》2018,53(7):434-440
On-line in-tube solid phase microextraction (in-tube SPME) coupled to high performance liquid chromatography and tandem mass spectrometry (HPLC-MS/MS) was successfully applied to the determination of selected triazines in water samples. The method based on the employment of a packed column containing graphene oxide (GO) supported on aminopropyl silica (Si) showed that the extraction phase has a high potential for triazines extraction aiming to its physical-chemical properties including ultrahigh specific surface area, good mechanical and thermal stability and high fracture strength. Injection volume and loading time were both investigated and optimized. The method validation using Si-GO to extract and concentrate the analytes showed satisfactory results, good sensitivity, good linearity (0.2–4.0 µg L?1) and low detection limits (1.1–2.9 ng L?1). The high extraction efficiency was determined with enrichment factors ranging from 1.2–2.9 for the lowest level, 1.3–4.9 intermediate level and 1.2–3.0 highest level (n = 3). Although the analytes were not detected in the real samples evaluated, the method has demonstrated to be efficient through its application in the analysis of spiked triazines in ground and mineral water samples. 相似文献
3.
4.
针对日益严重的环境污染、锅炉热效率低等问题,阐述了燃煤锅炉炉内空间分级燃烧技术、煤粉浓淡高效分离技术改造项目和特点,提出了对燃烧器系统、一次风管道、二次风系统和空预器系统等系统进行具体的低氮改造措施。分析了300 MW燃煤锅炉低氮改造后的热经济性和安全性。经试验验证,1号锅炉低氮改造后,锅炉NOx 排放量大幅减少,排放浓度降到了280 mg/m3。 相似文献
5.
Mo-modified Pd/Al2O3catalysts were prepared by an impregnation method and tested for the catalytic combustion of benzene. The catalysts were characterized by N2 isothermal adsorption, X-ray diffraction(XRD), X-ray photoelectron spectroscopy(XPS), temperatureprogrammed desorption of NH3(NH3-TPD), H2temperature-programmed reduction(H2-TPR), and high-angle annular dark-field scanning transmission electron microscopy(HAADF-STEM). The results showed that the addition of Mo effectively improved the activity and stability of the Pd/Al2O3catalyst by increasing the dispersion of Pd active components, changing the partial oxidation state of palladium and increasing the oxygen species concentration on the surface of catalyst. In the case of the Pd-Mo/Al2O3catalyst,benzene conversion of 90% was obtained at temperatures as low as 190°C, which was 45°C lower than that for similar performance with the Pd/Al2O3catalyst. Moreover, the 1.0% Pd-5% Mo/Al2O3catalyst was more active than the 2.0% Pd/Al2O3catalyst. It was concluded that Pd and Mo have a synergistic effect in benzene catalytic combustion. 相似文献
6.
需求视角的中国能源消费氮氧化物排放研究 总被引:7,自引:3,他引:4
基于经济投入产出生命周期评价(EIO-LCA)模型构建了中国1990—2010年能源消费氮氧化物完全排放矩阵,从需求的角度分析了氮氧化物排放在部门和不同需求间的分布结构,并通过情景模拟深入探讨了最终需求结构变化对氮氧化物排放的综合影响和拉动效应,以期探索中国氮氧化物减排的多元化途径.研究结果显示,1990—2010年中国氮氧化物排放总量从878万t上升到2398万t,历年来由工业部门拉动产生的氮氧化物占总量的比重高达70%左右;由最终消费拉动的氮氧化物排放比重逐年下降,资本形成和出口拉动的氮氧化物排放比重逐年上升.氮氧化物排放强度则从47.0 kg·万元-1降至6.0 kg·万元-1,其中,能源和交通部门的排放强度最高.通过情景模拟可以看出,提高最终消费比重,扩大内需有利于氮氧化物总量减排,尤其是对工业部门的减排效果显著.实现氮氧化物总量减排目标,要求在技术进步之外,积极寻求多元减排措施,以强化减排效果,突出能源和交通等重点部门的氮氧化物防治体系建设,并通过扩大内需优化最终需求结构以促进工业部门氮氧化物减排. 相似文献
7.
以两种新型涂铁改性石英砂(纳米氧化铁改性砂,Nano-OCS;氧化铁改性砂,IOCS)及普通石英砂(RQS)为研究对象,考察了两种新型改性砂对沉后水腐殖酸及浊度的直接过滤效果,对其反冲洗条件进行优化研究,并对3种滤料的过滤效果进行了比较.结果表明,1滤层厚度为45 cm时,最佳滤速为6 m·h-1;3种滤料对腐殖酸和浊度的直接过滤效果依次为:Nano-OCSIOCSRQS,其中两种涂铁砂对腐殖酸的去除率分别为71.70%和61.61%;2Nano-OCS和IOCS滤柱的反冲洗流程分4步,对应的流程及最佳操作条件为:首先,用0.5 mol·L-1NaOH的溶液浸泡,气冲强度13 L·s-1·m-2,气冲时间6 min;然后,用0.075 mol·L-1的NaOH溶液与空气同时反冲洗,NaOH溶液冲洗强度为8 L·s-1·m-2,气冲强度13 L·s-1·m-2,冲洗时间3 min;接着用0.015 mol·L-1的FeCl3溶液与空气同时反冲洗,FeCl3溶液冲洗强度为8 L·s-1·m-2,气冲强度13L·s-1·m-2,冲洗时间2 min;最后,用清水冲洗,冲洗强度8 L·s-1·m-2,冲洗时间4 min.两种涂铁砂反冲洗前后表面形态结构更加复杂、粗糙度增加,对腐殖酸去除率进一步提高.3当滤层厚度由45 cm增加到80 cm时,Nano-OCS对腐殖酸直接过滤的最高去除率由74.6%提高至80.3%,平均去除率由57.9%提高至68.5%. 相似文献
8.
9.
10.
新型纳米结构铈锰复合氧化物的磷吸附行为与机制研究 总被引:2,自引:1,他引:1
采用共沉淀法制备了一种新型铈锰复合氧化物吸附剂,对其进行了表征,并对磷吸附行为与机制进行了研究.表征结果分析表明,此氧化物由纳米级颗粒组成;铈锰复合氧化物中的铈氧化物有类似水合氧化铈的无定形结构;BET比表面积为157 m2·g-1,等电点为6.5.吸附实验结果表明,Langmuir吸附等温线模型可以更好地拟合铈锰复合氧化物对磷的吸附,最大吸附量为28.6 mg·g-1(p H=7.0);铈锰复合氧化物对磷具有较高的吸附速率,更符合准二级动力学模型;溶液p H对铈锰复合氧化物吸附磷的影响较为明显,随p H升高,吸附量降低;离子强度则影响不大;共存阴离子对吸附影响的大小顺序为Si O2-3CO2-3Cl-≥SO2-4.通过对铈锰复合氧化物吸附磷前后Zeta电位和红外谱图(FTIR)分析,可以推断磷在铈锰复合氧化物表面发生了特性吸附,磷酸根主要通过取代复合氧化物表面的金属羟基而被吸附去除. 相似文献